Random good picture Not show

91. While datapools are the easiest way to link test data with your tests in Rational Performance Tester, they can become inefficient with very large sizes (in general over 10,000 records).

92. The computer-aided test system of a complex hydraulic test bench is designed, and the hardware and software design scheme is given, realizing automatic test data recording and processing functions.

93. The effects of the three dewaxing solvents, including low benzene content, medium benzene content and no benzene, were compared by test data. The advantages of MIBK solvent was demonstrated.

94. Working principle, struture and function of engine test data base management system,[http://sentencedict.com/test data.html] data processing and graphing of engine test and test report creation are presented.

95. In this paper, the sound pressure level of each frequency of NO. 5 subway line noise is presented through the long-term research on it and test data in Yonghegong Station.

96. Based on geothermal well pumping test data evaluated recoverable resources; estimated 7.

97. Under the condition of CAT (Computer aided test), the test data about electro-hydraulic servo valve frequency response characteristic is processed with the discrete way.

98. Based on these full-scale burst test data, the failure pressure were computed by ASME B31G, DNV RP-F101 and PCORRC, respectively. The computation errors were showed in the charts.

99. For text analysis pLSA (Probability Latent Semantic Analysis) of Matlab algorithms, with test data and algorithm theory description.

100. The validity of unified hardening parameter H on describing the stress-strain properties of sands was confirmed by the triaxial test data of saturated sand from Taklamakan desert.

101. Method to conduct traction test for a fully hydraulic dozer is expatiated and procedure to process and analyze test data is described.

102. On the basis of a lot of test data for the slop bedsoil indoor, calculated various plans to 86km land- slide by computer and further testified the analysis of the mechanism and reason.

103. This paper also analysises the handling method of test data and the point estimation and interval estimate method for reliability life of car transmission.

104. The comparison of the calculation results and flight test data showed that the sea backscattering model of sea clutter was proper, which could be used for background model simulation.

105. The calculating results is consistent with the test data, it is shown that the calculation method is worthful in the technological application.

106. Selection basis and method on allowable contact stress of rolling ball-socket nozzle were described. Based on empirical formula and test data, several factors affecting allowable stress were analyzed.

107. It takes reasonable modifications of the previous test as test data of the test cycle, which maintains the original number of scan input and reduces the amount of test data effectively.

108. By actual test data, the leak detection system can rule out the stations affected by changes in working conditions can be accurately presented on the pipeline leak alarm and location information.

109. Finally, the turbopump fault detection approach was validated by LRE historical test data.

110. The calculation results are coincident well with the test data.

111. Hamiltonian function was fitted with the test data, which were the value sets of phase coordinates measured in free oscillation of the systems, and the.

112. Based on the test data of bored and driven piles the effect of construction technology on the end effect of pile is studied.

113. Horizontally pushing lifting jack of direct shear tests are operated on rock mass shear strength test. - center point group analysis is used for treating shear test data.

114. On the right side of the TDT pane you'll see a Test Data group with two columns: "In" and "Expected."

115. This method can describe the water flow velocity and vortex function distribution on all points of the reactor, with the simulation result in good coincidence with field test data.

116. Due to the difficulty to repeat fire tests of air -to- air missile and air-to-ground missile in a same launching condition, group test data are unavailable.

117. After tutorship test and appraise with same scale, and then use SPSS10. 0 to process and analysis the test data.

118. Furthermore, the industrial application of import vertical press filter is also discussed based on the test data and application status in output increase and energy saving.

119. Based on a turboshaft engine test data gathered during cold run, a method of calculating engine resistant torque and torque for acceleration was introduced.

120. Firstly, Beta distribution approximate is introduced and then converting the equipment test data into binomial test data is discussed for WCF method.